Products description
Properties
- DC Jack with 2.5mm pin for our power supplies with 2.5mm DC Plug
- Straight design with black mantle for optional use
- Connections for soldering
- Heads diameter: 8.93mm
- Diameter screwing area: 7.85mm (= ideal dia for drill hole if jacket should be glued)
- Diameter smooth area: 6.6mm (= ideal dia for drill hole if jacket should be screwed, e.g. in wood)
- Total length of the metal jacket: 25.4mm incl. soldering connection
Application
- Flexible DC Jacket for either stationary and countersink use or with black mantle and cable for flexible application
- To connect our inverters with our DC power supplies
- Can be countersank/screwed/glued e.g. into light frames and panels
- With cables and the black mantle as an external and flexible connection to a power supply
- General low voltage DC application where a DC Jacket with 2.5mm pin is needed
Additional notes
Polarity of the pin inside is usually + and the outer connection - . The DC supply cables of our inverters are red for + and black for - polarity.
Hint: For soldering the connection of the inside pin we recommend to plug in the plug of the power supply. This allows a mechanical stabilization and heat dissipation.
Customers who bought this product also bought the following products:
Housed EL-inverter for 5 Volt DC power supply. For EL-panels up to 105cm2. Dimensions (LxWxH): 17.5mm x 17mm x 19.3mm (without solder pins)
White silicone cap in rectangular shape for CCFLs between 2mm and 2.3mm diameter
EL-panel, azure blue, sliceable, laminated, outer dimensions(LxWxH): 18mm x 74mm x 0.42mm for LCDs in ART Multiverb III, ELKA EK33, EK44, EM33, EM44, ER33, ER44, E-MU EMAX I and II, Emulator II, SP12, SP1200, Korg DRV-2000, Kurzweil K1200, Roland Alpha Juno 1 and 2, Roland MKS-80, Roland PG1000, Sequential Circuits Prophet VS, Yamaha REV-7 and suitable for LCD Optrex DMC16207-AE DMC 16249, SHARP LCD LM16155
This Product was added to our catalogue on 04/07/2007.
