Products description
Properties
- small electronic EL-inverter without housing for a DC power supply between 2.2 and 5 Volt
- black and red cable for DC power supply
- 2 white wires for the EL-panel
- 1 orange cable for electronic switch ON with HIGH-signal
- small power coil (can be located elsewhere with a cable, max. 15 cm)
- small dimensions (LxWxH): 15mm x 14mm x 9.5mm (incl. height of coil, which can be placed elsewhere)
- low EMI
- silent, no noise
Main applications
- supply of our EL-panels between 20 cm2 and 60 cm2
- (the output can be increased by change of coil and capacitor)
- a flat and small driver for a subsequently integrated backlight, e.g. into your nostalgic handheld
- small and flat EL-developments
- replacement for defective or inefficient EL-driver
- small, flat and compact light sources of all kinds
Technical data
A detailled datasheet for the EL-driver chip can be found under -Downloads-
| Mechanichal | Tolerance | |
| Length L | 15 mm | +/- 0.1 mm |
| Width W | 14 mm | +/- 0.1 mm |
| Heigth H | 9.5 mm | +/- 0.1 mm |
| Weight incl. cables + coil | 2.5 g | +/- 0.2 g |
| Length supply cable | 70 mm | +/- 5 mm |
| Length output cable | 70 mm | +/- 5 mm |
| Working temperature | - 40 bis + 85°C | - |
| Storage temperature | - 40 bis + 85°C | - |
| Housing | no | - |
| Electrical | ||
| Supply voltage | 2.2 - max. 5 Volt DC | - |
| Supply current | 26 mA at 3 V | - |
| Working voltage | ~108 VRMS | +/- 10 VRMS |
| Supported EL-area | 20 - 60 cm2 | - |
| Sinuslike AC | 320 Hz | +/- 30 Hz |
| TTL ON/OFF-control | yes | - |
| Inductivity Lcoil | 5 mH/10 Ohm | +/- 10% |
| Capacity Clamp | 1500 pF | +/- 10% |
Additional notes
This inverter is matched to our EL-panels. The brightness of EL-panels from other manufacturers in operation with this inverter can be considerably weaker!
File
Customers who bought this product also bought the following products:
EL-panel, softyellow (= better contrast), sliceable, laminated, outer dimensions(LxWxH): 18mm x 74mm x 0.42mm for LCDs in ELKA EK33, EK44, EM33, EM44, ER33, ER44, E-MU EMAX I and II, Emulator II, SP12, SP1200, Korg DRV-2000, Kurzweil K1200, Roland Alpha Juno 1 and 2, Roland MKS-80, Roland PG1000, Sequential Circuits Prophet VS, Yamaha REV-7 and suitable for LCD Optrex DMC16207-AE, SHARP LCD LM16155
EL-panel, softyellow (= better contrast), sliceable, laminated, outer dimensions(LxWxH): 43mm x 155mm x 0.33mm for LCD Optrex DMF5005, AND711A, Toshiba TLX 711A, Korg i3, Korg Wavestation A/D, Korg Wavestation EX, Korg Wavestation WS1, Korg Wavestation WSA/D, Roland A-50, Roland A80, Roland D-70, Roland GC-8, Yamaha DEQ 5, Yamaha, QS300, Yamaha SY-77, Yamaha SY-99, Yamaha TG-77, Yamaha W5, Yamaha W7
EL-panel, azure blue, sliceable, laminated, outer dimensions(LxWxH): 43mm x 155mm x 0.33mm for LCD Optrex DMF5005, AND711A, Toshiba TLX 711A, Korg i3, Korg Wavestation A/D, Korg Wavestation EX Korg Wavestation WS1, Korg Wavestation WSA/D, Roland A-50, Roland A80, Roland D-70, Roland GC-8, Yamaha DEQ 5, Yamaha QS300, Yamaha SY-77, Yamaha SY-99, Yamaha W5, Yamaha W7
EL-panel, softyellow(= better contrast), incl. attached cables and connector, laminated, sliceable, outer dimensions(LxWxH): 46mm x 67mm x 0.42mm, backlight for Casio FZ-1, Hohner HS-1, HS-1E
EL-panel, pink-white, laminated, sliceable, outer dimensions(LxWxH): 39mm x 93mm x 0.42mm
This Product was added to our catalogue on 18/02/2010.
electronic »
More information on your personal page »
